Leading A-Series engine specialist since 1981
A must for any high performance engine build, the MED straight-cut drop gear set is stronger and more reliable than the standard helical design, with less side-loading effect.
The input and primary gears are identical to the MED Roller Bearing Drop Gear Set, but the idler gear suits standard replacement needle roller bearings (available here) to save costs. Where the budget allows, or for full competition, we would highly recommend the upgraded roller bearing design.
MED drop gear features
Gear set choice
We can supply alternative ratio sets by changing the primary gear/input gear. See the Additional Information tab for more on changing drop gear ratios. If you're happy with your current gear ratios, select the 1:1 option.
Both 1275cc and 998cc sets can be chosen from the dropdown menu above. For reference, A-plus sets have a 22mm idler gear shaft and pre-A-plus have a 19mm idler shaft.
For fast road applications we would recommend setting the primary and idler gear end float between 0.004-inch to 0.006-inch. For competition, a marginally larger tolerance may be suitable - contact us if you're unsure.
See the MED Roller Bearing Drop Gear Set for our upgraded competition-grade gears.
The MED drop gear sets are available in three different ratios, which can be used to tweak the final drive ratio. Changing the effective final drive ratio will either improve acceleration or top speed potential, although one will always come at the expense of the other.
We can do this by changing the tooth count on either the idler gear or primary gear to 23 or 24 teeth. The idler gear in the middle remains at 30 teeth regardless.
The table below shows the various tooth counts and the effect on the drop gear ratio:
|Drop gear set configuration|
|Input gear||24 teeth||24 teeth||23 teeth|
|Idler gear||30 teeth||30 teeth||30 teeth|
|Primary gear||24 teeth||23 teeth||24 teeth|
To calculate your effective final drive ratio based on the above, simply multiply your existing final drive ratio by the number of the drop gear set. So for example, a 3.47:1 final drive ratio with a 1:1.043 drop gear set then becomes 3.62:1. Remember that the higher the number, the shorter the gearing will be, so this change will result in a higher engine RPM for a given speed.
Changing the primary gear is easier than removing the differential to change the final drive ratio, so racers use this to adjust their gearing to suit different circuits. Keeping an engine in its peak powerband for longer will result in a faster lap time.
See the following table for our final drive conversions using the various drop gear sets:
|Drop gear ratio adjustment|