DTA T2 IGNITION ECU & LOOM
![Arrow Arrow](http://www.med-engineering.co.uk/cdn/shop/t/2/assets/tab--arrow.png?v=26440831803762552921668523220)
Description
The DTA T2i gives the best of both worlds for the high performance A-Series engine - a programmable distributor-less ignition system that retains the simplicity of fueling with carburettors.
It will offer improved power and drivability once correctly mapped on a rolling road or dyno, for race or road applications.
DTA software is known for its user-friendly interface and is widely used by professional tuners.
We've teamed up with DTA to bring you a Mini-specific professional wiring loom to make installation simple. The loom comes with connections for the following:
- Crank position sensor
- Coil pack
- MAP sensor
- Throttle Position Sensor
- Fused 12-volt ignition
- Ground
- Tacho
- Shift light
The loom has been designed to fit the coil pack up on a Mini bulkhead, to plug straight into our crank position sensor kits and for the ECU to fit around the dashboard area.
For a complete installation setup, we also offer the MED Ignition Management Kit.
T-Series engine control units are powered by an all-new, automotive specific, multi-core processor. They feature Bosch lambda controllers for maximum accuracy, multiple safety redundancies, high resolution map tables, fully configurable I/O and up to 32Mb of up to 1Khz logging with compression algorithms for fast log downloads.
The PC software has a user-friendly, responsive design for better readability on high resolution monitors using high scaling (DPI). It features a full oscilloscope for crankshaft/camshaft signal analysis and allows firmware to be upgraded without special cables or separate software.
Related Products
![DTA T2 IGNITION ECU & LOOM](http://www.med-engineering.co.uk/cdn/shop/products/med-5930-dta-new.jpg?v=1676572909&width=1445)